Dell POWEREDGE R610 - Manual (Page 164)

164 Jumpers and Connectors
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening and Closing the System."
3 Move the password jumper to the "disabled" position to clear the password.
See Table 6-1.
See Figure 6-1 to locate the password jumper on the system board.
4 Close the system.
5 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
The existing passwords are not disabled (erased) until the system boots
with the password jumper plug in the "disabled" position. However, before
you assign a new system and/or setup password, you must return the
jumper plug to the enabled position.
NOTE: If you assign a new system and/or setup password with the jumper
plug still in the "disabled" position, the system disables the new password(s)
the next time it boots.
6 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7 Open the system. See "Opening and Closing the System."
8 Move the password jumper back to the enabled position to restore the
password function. See Table 6-1.
9 Close the system.
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning
a System Password."
System Board Connectors
See Figure 6-1 and Table 6-2 for the location and description of the system
board connectors.