Dell Inspiron 3500 User Manual

Page 104

Text mode
Original mode

Fan Cover and Fan Removal: Dell™ Inspiron™ 3500 Portable Computer

You can remove the fan cover and fan without removing the palmrest. To remove the fan cover and fan, see the exploded view of the

base assembly

and perform the

following steps:

1. Remove the

display assembly

2. Remove the

keyboard

3. Remove the

heat-sink fin cover

4. Remove the 5-mm screw securing the fan cover.
5. Remove the fan cover.
6. Disconnect the fan cable from connector J6 on the system board.
7. Remove the fan.

Type of Screw

Torque

FPH 2.5 x 5 (1) 3.0–3.5 kgf-cm

NOTE: Note the positioning of the fan and the routing of the fan cable carefully so that you can duplicate it during installation. An arrow on the top of
the fan indicates that the flow of air is from the outside of the computer in to the board.