Dell PowerEdge RAID Controller H700 - Manual (Page 92)

92 Configuring and Managing RAID
3 Press to display the menu of available actions.
4 Press the down-arrow key to select Consistency Check.
5 Press the right-arrow key to display the available actions (Start, Stop).
6 Select Start and press to run a Consistency Check.
The Consistency Check runs and checks the redundancy data in the
virtual disks.
7 After you start the Consistency Check, press to display the
previous menu if needed.
Importing or Clearing Foreign Configurations Using the VD Mgmt Menu
When a foreign configuration exists, the BIOS screen displays the message
Foreign configuration(s) found on adapter. In addition,
a foreign configuration is displayed on the right side of the Ctrl Mgmt screen.
You can use the VD Mgmt menu to import the existing configuration to the
RAID controller or clear the existing configuration. In addition, you can view
the foreign configuration from the Foreign View tab without importing the
configuration.
NOTE: The controller does not allow an import of configurations that results in
more than 64 virtual disks.
NOTE: To import a secured foreign configuration, see "Security Key and RAID
Management" on page 121.
Perform the following steps to import or clear foreign configurations:
1 During bootup, press when prompted by the BIOS screen.
The VD Mgmt screen is displayed by default.
2 On the VD Mgmt screen, highlight the Controller #.
3 Press to display the available actions.
PERC7.2_UG.book Page 92 Thursday, March 3, 2011 2:14 PM