Dell PowerEdge 2600 - Manual (Page 16)

Back to Contents Page
Group, Meaning LED 1 LED
2 LED
3 LED
4 LED
5
System is healthy, AC power not present, bad 3.3 V AUX, or PDM not
connected. OFF OFF OFF OFF OFF
1 - Cables and Installed Components
1 Control panel cable not present BLINK OFF OFF OFF OFF
2 Backplane cable not present BLINK OFF OFF OFF ON
3 VRM_P1 missing BLINK OFF OFF ON ON
4 PROC1 missing BLINK OFF ON OFF OFF
5 PROC2 present but VRM_P2 missing BLINK OFF ON OFF ON
6 VRM_P1 present but PROC1 missing BLINK OFF ON OFF OFF
7 VRM_P1 and VRM_P2 vendor mismatch BLINK OFF ON ON ON
8 PROC1 and PROC2 core voltage (VID) mismatch BLINK ON OFF OFF OFF
9 PROC 1 and PROC 2 bus frequency mismatch BLINK ON OFF OFF ON
10 DDR 200 memory in 533 MHz BLINK ON OFF ON OFF
11 PROC1 heat sink not installed properly. Thermtrip on PROC1 BLINK ON OFF ON ON
12 PROC2 heat sink not installed properly. Thermtrip on PROC2 BLINK ON ON OFF OFF
2 - VRMs and POWERGOOD
1 PD_ON# from the ICH3 not happening OFF BLINK OFF OFF ON
2 Power supply not turning ON. +12 V bad or missing. OFF BLINK OFF ON OFF
3 +1.2V is not good. OFF BLINK OFF ON ON
4 +1.8V is not good. OFF BLINK ON OFF OFF
5 +1.25V is not good. OFF BLINK ON OFF ON
6 +2.5V is not good. OFF BLINK ON ON OFF
7 +3.3V is not good. OFF BLINK ON ON ON
8 +3.3V_PCI is not good. ON BLINK OFF OFF OFF
9 +5V is not good. ON BLINK OFF OFF ON
10 System POWERGOOD missing. Bad U6009. ON BLINK OFF ON OFF
11 Standby POWERGOOD missing. Bad +5V_AUX or +1.8V_AUX. ON BLINK OFF ON ON
12 VRM_P1 is not good. ON BLINK ON OFF OFF
13 VRM_P2 is not good. ON BLINK ON OFF ON
3 - NOPOST NO VIDEO (chipset)
1 CPU POR is not high. North bridge chip on the planar has likely failed.
Replace planar. OFF OFF BLINK OFF ON
2 ICH3 PCI Reset is not high. ICH3 chip on the planar has likely failed.
Replace planar. OFF OFF BLINK ON OFF