Baumer G1-G2-G0-GE-GB-GXxxx - Manual (Page 52)

Manual_CANopen_BIDE_EN.docx 52/52 Baumer IVO GmbH & Co. KG
21.11.12 Villingen-Schwenningen, Germany
7.2.5. Terminal assignment
Pin Terminal Explanation M12-connector (male/female)
1 GND Ground connection relating to UB
2 UB Supply voltage 10...30 VDC
3 GND Ground connection relating to UB
4 CAN_H CAN Bus signal (dominant High)
5 CAN_L CAN Bus signal (dominant Low)
Terminals with the same designation are connected to each other internally and identical in their functions.
Maximum load on the internal clamps UB-UB and GND-GND is 1 A each.
Carefully plug the bus cover onto the D-SUB plug of the basic encoder, then press only via the sealing
rubber, taking care not to tilt it. The bus cover must rest fully against the basic encoder.
Tighten both the fastening screws firmly in the same direction.
The encoder housing and braided shield of the connecting cable are only ideally connected if the bus cover is
resting fully on the basic encoder (positive locking).
7.3. Display elements (status display)
A dual LED is integrated at the back of the bus cover.
LED green LED red Status
Off Off Supply voltage not connected
Flashing Off Pre-operational mode
On Off Operational mode
On Off Stopped/Prepared mode
Off Flashing Warning
Off On Error