Edge Lighting Light Channel, Surface Mount 24V RGB User Manual
Surface mount light channel rgb, 24vdc, Install the light channel, Installation instructions for

Installation Instructions for
Surface Mount Light Channel RGB, 24VDC
904-LCSM-24V-RGB-01
Install the Light Channel
1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
A
2
MOUNTING CLIP
1: Determine the location for the Light Channel.
2: Place the clips on the surface every 2' (measure from the
the center slot of the mounting clip) and mark the screw
locations.
2 FOOT
2 FOOT
B
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
WALL
3
4
ANCHOR
5: Line up the mounting clips to the anchors and secure it to
the anchors by tightening the two #8-32 screws to each
clip.
C
MOUNTING CLIP
SURFACE
ANCHOR
SCREW
5
6: Snap each Light Channel into the spring clips.
D
MOUNTING CLIP
SURFACE
6
LIGHT CHANNEL
1
LCSM-24V-_-RGB-_
NOTE:
mounting the clips to a wood surface directly. ANCHORS ARE
NOT PROVIDED.
Steps 3 to 5 are for drywall mounting. Omit these steps if
SURFACE