Edge Lighting 45° Light Channel 24V High Output User Manual
Light channel 45, Install the light channel, Installation instructions for

Installation Instructions for
Light Channel
45°
904-LC45-24V-01
Install the Light Channel
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
-
-
45 degree channel comes 12" to 120" long in a single
piece. Multiple 45 degree channels can be connected
together in series or parallel by connecting the 8ft pigtail
wires. These wires are rated for CLASS 2 (through the
wall) installation. Maximum 25' of the 45 degree channels
could be connect together when TEB-75L-24DC (Electronic
low voltage dimming) power supply is used, or 40' if the
PSB-96W-010-24VDC (0-10 dimming) is used.
This instruction shows typical installation.
IMPORTANT INFORMATION
A
1: Determine the location for the Light Channel.
2: Place the clips on the surface every 20" (measure from the
the center slot of the mounting clip) and mark the screw
locations.
LC45-24V-_
20"
AWAY
(TYP)
WOOD
MOUNTING CLIP
1
2
2
NOTE:
Remote power supply must be installed within 40 feet.
The low voltage 24VDC, Class 2 Wires must be present before
installing the channel. Refer to the installation instructions
provided with the power supply or general diagram on page 2.
1
LC45C-24V-_
B
SURFACE
3
4
ANCHOR
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
NOTE:
mounting the clips to a wood surface directly. ANCHORS ARE
NOT PROVIDED.
Steps 3 to 4 are for drywall mounting. Omit these steps if
5: Line up the mounting clips to the anchors and secure it to
the anchors by tightening the three #6 screws to each clip.
C
#6 SCREW
MOUNTING
CLIP
5
5