Edge Lighting Light Channel, Surface Mount 24V - Manual

Installation Instructions for
Surface Mount Light Channel, 24VDC
904-LCSM-24-01
Install the Light Channel
1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2013 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
A
2
MOUNTING CLIP
1: Determine the location for the Light Channel.
2: Place the clips on the surface every 2' (measure from the
the center slot of the mounting clip) and mark the screw
locations.
2 FOOT 2 FOOT
B
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
WALL
3
4
ANCHOR
5: Line up the mounting clips to the anchors and secure it to
the anchors by tightening the two #8-32 screws to each
clip.
C
MOUNTING CLIP
SURFACE ANCHOR
SCREW
5
6: Snap each Light Channel into the spring clips.
D
MOUNTING CLIP
SURFACE 6
LIGHT CHANNEL
1
LCSM-24V-_
NOTE:
mounting the clips to a wood surface directly. ANCHORS ARE
NOT PROVIDED.
Steps 3 to 5 are for drywall mounting. Omit these steps if
SURFACE