Edge Lighting Light Channel, Surface Mount 24V - Manual (Page 3)

BACKING
2
3
Replacing the Soft Strip
H
SOFT STRIP
REMOVE OLD
SOFT STRIP
1: Carefully pull existing old Soft Strip completely off the
channel.
2: If there is Soft Strip residue on the channel apply in
moderation WD-40, or Goo Gone, or a mixture of warm
water and lemon oil to the corner of a clean, dry towel.
Gently buff the area containing the adhesive residue with
small circular motion until it is completely removed.
NOTE: Avoid bending the soft strip in sharp vertical angles which
may damage the LEDs. Soft Strips do not bend horizontal. Use
proper directional connectors for horizontal turns.
CHANNEL
1
3: Carefully remove the backing from the new LED soft strip,
make sure not to remove the tape from the soft strip. Firmly
press down the adhesive portion of the soft strip onto the
channel while removing the rest of the backing, making sure
there are no air bubbles that can cause surface irregularities.
input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+)
BLUE (RETURN-)
YELLOW (DIM RETURN-)
INPUT
120VAC
LIGHTOLIER:
ZP600FAM120
CONTROLLER
PSB-96W-010-24VDC
24VDC
RED 24VDC+
BLACK 24VDC- PURPLE 1-10V
GRAY 1-10V
RED 120VAC (HOT)
BLACK (HOT)
WHITE (NEUTRAL)
GND
SURFACE MOUNT
LIGHT CHANNEL
DIMMING
GENERAL WIRING DIAGRAM