Edge Lighting Soft Line Mounting Hardware for Indirect Lighting User Manual
Soft line, Install the soft line, Installation instructions for

Installation Instructions for
Soft Line
Install the Soft Line
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
1
wire with a wire nut.
2: Connect the black power feed turnbuckle wire to the red
driver wire with a wire nut.
: Connect the red power feed turnbuckle wire to the red driver
904-SL-03
1
SL-_
NOTE:
The low voltage wires should be present in the electrical
box. Refer to the instructions provided with the power supply to
install the low voltage wires before proceeding with the steps
below.
A
2
1
3: Place all wires inside the electrical box.
4: Secure the power feed turnbuckle to the electrical box by
tightening the two provided #8-32 screws.
B
#8-32 SCREW
ELECTRICAL
BOX
POWER FEED
TURNBUCKLE
ELECTRICAL
BOX
POWER FEED
TURNBUCKLE
3
4
4
C
5: Determine the location for the non-power feed turnbuckle,
either face to face with power feed turnbuckle (up to 40'
away) or diagonal up to 120° from the power feed
turnbuckle.
6: Use only a 1-3/4" circular saw to cut out the drywall where
the turnbuckle is going to be installed.
7: Place the turnbuckle into the hole and mark the two screw
holes.
5
NON-POWER FEED
TURNBUCKLE
HOLE
6
7