Edge Lighting PSB-60W-ELV-12VDC, 60 Watt 12 Volt DC Power Supply User Manual
60 watt 12 volt dc power supply, Install the power supply, Installation instructions for

PSB-60W-ELV-12VDC
Installation Instructions for
60 Watt 12 Volt DC Power Supply
904-PSB-60W-ELV-12VDC
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
SAVE THESE INSTRUCTIONS!
- Do not install this power supply in a wet location.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.
- Turn the electrical power off before modifying the lighting
system in any way.
- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
- For dimming options refer to EDGELIGHTING.COM.
* See LED fixture installation instructions for proper
placement.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions"
before installation.
- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.
- Load the power supply to MAXIMUM 60 Watts.
GENERAL INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
© 2012 Edge Lighting. All Rights Reserved.
Install the Power supply
A
1: Loosen and remove the four Phillips screws on the top &
sides of the power supply case to remove the cover.
2: Secure the power supply case to the desired location with
the four #6 screws provided.
PHILLIPS
SCREW
B
CONDUIT
COVER
POWER
SUPPLY
CASE
1
2
3
5
7b
POWER SUPPLY
6
3: Install conduits from the electrical box panel and the
dimmer electrical box (if used) to the power supply case.
4: DO NOT connect the power wires to the panel at this time.
5: Ground the power supply housing in accordance with local
electrical codes.
6: Connect the neutral power wire to the white power supply
wire and the wire going to the neutral of the dimmer with a
wire nut.
7a: In case of not dimming, connect the hot power wire to the
black and brown power supply wire and to the hot switch
leg wire with a wire nut (not shown). Refer to the wiring
diagram on page 2.
7b: In case of dimming, connect the hot power wire to the
black power supply wire and the wire connecting to the
dimmer hot wire with a wire nut. Connect the brown power
supply wire to the switch leg hot wire coming from the
dimmer with a wire nut. Refer to the wiring diagram on
page 2.
7b
CONDUIT
1