Edge Lighting Vision 8 - Manual (Page 3)

E
3
HOUSING
OPENING
TRIM
7: Place all wires inside the housing and insert the top spring
clip into the housing.
8: Bend the bottom spring clip of the trim towards the housing
while pushing it into the housing.
BOTTOM SPRING CLIP
F
9: From the inside of the trim, push the back end of the glass
disk upwards until the front end of glass disk slides out of
the metal frame.
GLASS DISK
METAL FRAME
TRIM
G
TRIM
10: Carefully pull the socket assembly out.
11: Push the lamp pins completely into the socket assembly
holes.
12: Replace the socket assembly completely into the trim
housing.
13: Slide the glass disk half way into the metal frame opening
and rotate the front up while inserting the remaining
portion in.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 20 Watt Bi-Pin Halogen Lamp.
NOTE: Use only fingers and a soft cloth to install the lamps.
LAMP
SOCKET
ASSEMBLY
8
8 9
10
11
13
7