Wiring the trims – Edge Lighting Port LED Components User Manual

Page 6

GROUND

TRIM

NOTE:

consumes 2.4 watts.

Each fixture contains an integrated LED lamp. Each Port

Wiring the Trims

LOW VOLTAGE WIRE SIZE CHART

TRANSFORMER
WATTAGE

WIRE SIZE

FOR UP TO 13 FT

WIRE SIZE

FOR 14-20 FT

WIRE SIZE

FOR 21-34 FT

WIRE SIZE

FOR 34-52 FT

12V 60W

TE-60L-12

#14 AWG

#12 AWG

#10 AWG

#8 AWG

Overall Wiring Diagram

PORT

12V AC (RED)

120V NEUTRAL (WHITE)

120V HOT (BLACK)

12 VAC

POWER SUPPLY

TRIM HOUSING

1: Remove the plastic caps.

2: Connect each trim wire to one power wire in the electrical
box with a wire nut.

3: Place all wire connections inside the electrical box and push
the trim completely into the trim housing opening.

4: Repeat steps 2 and 3 for other trims.

NOTE:

(provided) onto the trim to prevent water leaking inside the
electrical box. Use water proof outdoor wire nuts for power
connection.

For outdoor installation, place the water proof gasket

GASKET

GASKET INSTALLATION

FOR OUTDOOR

GASKET

NOTE:

provided with the PORT-LL to install the beam control accessories
in each trim prior to wiring the trims.

If using the PORT-LL accessory, refer to the instruction