Edge Lighting Port LED Components - Manual (Page 4)

Indoor Floor Trim Housing Installation
4
2: Insert the provided plastic caps to all trim housing to prevent
dust and debris from entering inside the box.
3: Finish the floor installation up to the plastic cap.
4: Refer to the "Install the Trims" section.
J
PLASTIC
CAP
PLASTIC CAP
3
1: Align and secure the each trim housing to the octagon
electrical box holes with the two #8-32 screws (not
provided).
I TRIM HOUSING
#8-32
SCREW
CONDUIT
TRIM HOUSING
JOIST
SUBFLOOR
FLOOR
1
12VAC 12VAC 12VAC 12VAC
3
1
4"
1.6"
2.4"
2
Indoor Drywall Installation Using an Electronic LED
Power Supply (TE-60L-12)
NOTE:
the steps below and refer to the "Indoor Drywall Installation Using
Magnetic Remote Transformer" section.
If using a magnetic transformer to power the fixtures omit
NOTE: Use only octagon boxes to install the trim housings indoor.
1: Install an octagon box onto the stud next to the panel to fit
the LED power supply (TE-60L-12) and to branch the power
to all octagon boxes.
2: Install conduit and run the 120 volt power wires from the
panel to the branching octagon box.
3: Install all octagon boxes for the housing trims and run
conduits from the branching octagon box to all these octagon
boxes.
4: Run proper wire sizes from branching electrical box to all
fixture electrical boxes using the "Wire Size Chart" on page 6.
5: Follow steps 5 through 8 on page 1 using drawing B to
connect the wires to the power supply.
NOTE:
depth (1.6") for total of 4" depth should be considered when
positioning and mounting an octagon on side of the stud.
Port trim housing depth (2.4") along with octagon box
K
PANEL
STUD
CONDUIT
OCTAGON
BOX WITH
BRACKET
1
120VAC
12VAC
POWER
SUPPLY
3
DRYWALL
TRIM HOUSING
OCTAGON BOX
TRIM HOUSING
MUST BE
FLUSH TO
DRYWALL
4"
MINIMUM
STUD