Edge Lighting TV LED - Manual

Installation Instructions for
TV LED
904-TV-W-L1-03
SAVE THESE INSTRUCTIONS!
- RISK OF FIRE:
- This product is for wall mount applications only.
- This product can mount to a standard 4" electrical box
with a plaster ring or an octagon electrical box.
- This product is not dimmable.
This product must be installed 4 ft above
the ground for wet locations.
IMPORTANT INFORMATION
1
TV-W-L1-_ 1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
Install the Fixture
A
2.5MM ALLEN
WRENCH
M5 SET SCREW
1: Back out (do not remove) the two M5 set screws on bottom
of the fixture with the provided 2.5mm Allen wrench.
2: Slide the backplate along with the silicone gasket away from
the fixture, do not remove them.
BACKPLATE
FIXTURE BODY
1 1
SILICONE
GASKET
2
NOTE: Use the universal crossbar (provided) when
mounting the fixture to an octagon box. There will be a
1/16" gap between the fixture and the wall when the
universal crossbar is used. Caulking around the fixture will
be needed when the universal crossbar is used in outdoor
applications.
3: Connect the blue (NEUTRAL) LED driver wire to the neutral
power wire with a wire nut.
4: Connect the brown (HOT) LED driver wire to the hot power
wire with a wire nut.
5: Place the LED driver and wire connections inside the
electrical box.
B
WIRE NUT
ELECTRICAL BOX
LED DRIVER
3
5
4