Edge Lighting Stream - Manual

STREAM-W-H1-_
M2-IND-_
904-STREAM-W-H1-04
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only and it should be
installed as an up light (lamp facing up).
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a low voltage electronic
dimmer.
Installation Instructions for
Stream
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Fixture
1
B
TRANSFORMER
WIRE NUT
3
4
3: Connect the white transformer wire to the neutral power
wire with a wire nut.
4: Connect the black transformer wire to the hot power wire
with a wire nut.
5: Place the transformer and wire nut connections inside the
electrical box.
1:
canopy (Do Not Remove) with the provided 3mm Allen
wrench.
2: Pull the mounting plate out of the fixture canopy.
Loosen the two M6 set screws on the top of the fixture
A
MOUNTING PLATE
FIXTURE CANOPY
M6 SET
SCREW
3MM ALLEN
WRENCH
2
1 1
5
6:
provided #8-32 screws using the 3/32 Allen wrench. Make
sure that the crossbar is grounded in accordance with local
electrical codes. Mount the crossbar to the electrical box holes with the
#8-32 SCREW
CROSSBAR
ELECTRICAL
BOX HOLE
C
6 6
3/32 ALLEN
WRENCH
© 2009 Edge Lighting. All Rights Reserved.