Edge Lighting Square Crystal - Manual (Page 2)

2
8:
provided #8-32 screws using the 3/32 Allen wrench.
9: Make sure that the crossbar and transformer wire are
grounded in accordance with local electrical codes.
Mount the crossbar to the electrical box holes with the
CROSSBAR
ELECTRICAL BOX HOLE
D
8
NOTE: The two center holes (spaced 2-1/16" apart) on crossbar
should be oriented vertically when mounting to the electrical box
holes.
CROSSBAR
E
CENTER
HOLE
MOUNTING PLATE
#8-32 SCREW
10: Feed the transformer wires through the mounting plate
center hole.
11: Align the mounting plate so that the grooved edge of the
bracket faces up ward. Secure the mounting plate to the
crossbar with the provided #8-32 screws using the 3/32
Allen wrench.
10
3/32 ALLEN WRENCH
11
GROOVED
EDGE
12: Connect each transformer low voltage wire (blue wire) to
one fixture wire with a wire nut.
F
FIXTURE CANOPY MOUNTING PLATE
11
13: Place all wires and wire nut connections inside the fixture
canopy.
14: Place the fixture canopy onto the mounting plate and
secure it by tightening the two M6 set screws with the 3mm
Allen wrench.
G
FIXTURE CANOPY
MOUNTING
PLATE
M6 SET SCREW
3MM ALLEN
WRENCH
CENTER HOLE
2-1/16"
11
12
12
13
14
#8-32 SCREW
8
3/32 ALLEN WRENCH