Edge Lighting Regal LED User Manual
Regal led, Install the fixture, Installation instructions for
SAVE THESE INSTRUCTIONS!
REGAL-L1-_
M2-IND-_
Installation Instructions for
Regal LED
904-REGAL-L1-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
IMPORTANT SAFETY INSTRUCTIONS
Install the Fixture
1:
body to detach front cover.
Remove the two thumb nuts on the sides of the fixture
1
A
© 2014 Edge Lighting. All Rights Reserved.
B
2: Remove the front cover from the fixture.
3: Slide the glass panels out of the slots in the fixture.
1
1
THUMB NUTS
FRONT COVER
FRONT COVER
4: Loosen and remove the two hex nuts and lock washers from
the center of fixture body to remove the crossbar assembly.
2
FIXTURE
GLASS PANEL
3
FIXTURE
4
4
HEX NUT/
LOCK WASHERS
CROSSBAR
- Use this fixture indoors only.
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- This product can mount to either a 4" square junction box
with round plaster ring or an octagon junction box.
- This product can be dimmed with a standard low-voltage
electronic dimmer.
- This product must be installed by a qualified electrician.
- Before beginning any electrical work, ensure that
power to the junction box is turned OFF.