Edge Lighting Dial LED User Manual
Dial led, Disassemble the fixture & install the driver, Installation instructions for

Installation Instructions for
DIAL LED
904-DIAL-W-L1-03
SAVE THESE INSTRUCTIONS!
- RISK OF FIRE:
- This product is for wall mount applications only.
- This product can mount to a standard 4" electrical box
with a plaster ring or an octagon electrical box.
- This product is not dimmable.
This product must be installed 4 ft above
the ground for wet locations.
IMPORTANT INFORMATION
1
DIAL-W-L1-SA
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
Disassemble the Fixture & Install the Driver
1: Loosen the two Phillips screws to remove the cover.
A
PHILLIPS
SCREW
FIXTURE
COVER
B
M6 SCREW
GLASS
SHADE
2: Loosen the two M6 screws using the provided 3mm Allen
wrench to remove the backplate. Use a small flathead
screwdriver to remove the backplate from the glass shade.
BACKPLATE
1
1
1
2
2
3: Connect the blue (NEUTRAL) LED driver wire to the neutral
power wire with a wire nut.
4: Connect the brown (HOT) LED driver wire to the hot power
wire with a wire nut.
5: Place the LED driver and wire connections inside the
electrical box.
C
WIRE NUT
ELECTRICAL BOX
LED DRIVER
3
5
4
3MM ALLEN
WRENCH
2
SMALL
SCREW
DRIVER