Edge Lighting Alpha LED - Manual (Page 2)

E
9
9
9: Connect each power supply wire to a fixture body wire
(either one) with a wire nut.
F
FIXTURE
BODY HOLE
10
10: Place all wires and wire nut connections behind the fixture
body.
11: Place the left fixture body hole onto the mounting bracket
tab.
MOUNTING BRACKET TAB
11
2
6: Feed the power wires through the canopy center hole.
7: Make sure that the canopy is grounded in accordance with
local electrical codes.
8: Secure the canopy to the universal crossbar by tightening
the two #8-32 screws through the mounting bracket holes
into the two inner threaded crossbar holes.
6
8
CANOPY
#8-32 SCREW
MOUNTING
BRACKET
POWER
WIRES
D
FLAT HEAD
PHILLIPS SCREW
G
FIXTURE BODY
CANOPY 12
12: Secure the right fixture body hole with the flat head
Phillips screw provided.
H
GLASS COVER
SPRING CLIP
13
13
13: Loosen the screws on the spring clips (Do Not Remove)
to insert the glass cover under the clips. Slightly tighten the
spring clip screws to secure the glass cover in place.