Edge Lighting 4" Fast Jack Canopies Without Transformers - Manual

SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product mounts to a 4" standard electrical box or
octagon electrical box using the 2" plaster ring provided.
- A remote transformer should be installed prior to
beginning this installation.
Installation Instructions for 2
Transformer
" Round & Square Fast Jack For Remote
904-FJC-2RD-2SQ-REMOTE_01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected] FJC-2RD-
© 2010 Edge Lighting. All Rights Reserved.
Install 2" Plaster Ring Adapter (New Construction)
1
JUNCTION BOX
1: Install the 2" Plaster Ring Adapter to the junction box using
two #8-32 screws.
2: Use a circular saw to cut out the drywall section where the
junction box opening is.
3: Install the drywall. If necessary, plaster and finish the
drywall.
4: Complete installation per “Install Fast Jack Port” section on
Page 2.
2" PLASTER RING
ADAPTER
#8-32
SCREW
NOTE: Junction box must be mounted to allow clearance of
½" between the face of the junction box and the drywall
surface.
1
1
FJC-2SQ-
Install 2" Plaster Ring Adapter (Remodel)
CEILING 1: Cut away the drywall where the junction box is located.
2: Remove the plaster ring by removing the #8-32 screws.
3: Install the 2" Plaster Ring to the junction box using two
#8-32 screws.
4: Plaster and finish around the junction box opening.
5: Complete installation by following steps in “Install Fast Jack
Port” section on Page 2.
CEILING CUT DRYWALL
STANDARD
PLASTER
PLATE
#8-32
SCREW
#8-32
SCREW
1
2
2
A
CEILING
3
2 1/4"
B
C