Edge Lighting Cody 2 - Manual

FJ-COD-2-_
M2-COD-2-_
M-COD-2-_
Cody 2 LED Installation Instructions for
904-FJ-COD-2-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail & Fast Jack Systems.
IMPORTANT INFORMATION
1
Install the to the Monorail (MC-FJ-_) fixture
HOUSING
CONNECTOR
(DISCARD)
1
A
1: Remove the Monorail housing connector from the Monorail
Fast Jack housing and discard it.
MONORAIL FAST
JACK HOUSING
FIXTURE HOUSING
CONNECTOR
2: Place the Monorail Fast Jack housing onto the Monorail and
use fingers to tighten the fixture housing connector to the
Fast Jack housing. Make sure that the fixture housing
connector is not cross threaded.
B
MONORAIL FAST
JACK HOUSING
2
2
MONORAIL
Install the to Monorail 2 Circuit Connector (M2C-FJ-_) fixture
MONORAIL 2 CIRCUIT
FAST JACK HOUSING
HOUSING
CONNECTOR
(DISCARD)
1
C 1: Remove the Monorail 2 Circuit housing connector from the
Monorail 2 Circuit Fast Jack housing and discard it.
2: Place the Monorail 2 Circuit Fast Jack housing onto the
Monorail 2 Circuit and use fingers to tighten the fixture
housing connector to the Fast Jack housing. Make sure
that the fixture housing connector is not cross
threaded.
D
1
MONORAIL 2 CIRCUIT
MONORAIL 2 CIRCUIT
FAST JACK HOUSING
FIXTURE
CONNECTOR HOUSING
1