Edge Lighting 2 Circuit 4" Round Adjustable Power Feed Canopies - Manual

SAVE THESE INSTRUCTIONS!
M2P-4RD-A-_
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
Install the Canopy
1
904-M2P-4RD-A-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Installation Instructions for
Monorail 2 Circuit Adjustable 4" Round
Single Power Feed Canopy
1: Loosen the two M4 set screws on the plastic disk with the
2mm Allen wrench provided.
2: Adjust the power feed wires to the desired height (from top
of the canopy to top of the Monorail - Illustrated as "H" in
diagram A) by pushing the power feed wires into the canopy.
3: Tighten the two M4 set screws firmly with the 2mm Allen
wrench.
4: Leave at least 6" of the power feed wires behind the canopy.
Trim off the excess power feed wires with a sharp cutter.
Strip 1/4" of insulation off of the power feed wires.
A
2MM ALLEN WRENCH
M4 SET
SCREW
POWER FEED
WIRES
PLASTIC DISK
2
4
H
1
3
CANOPY
B
5: Turn the power to electrical box off.
6: Connect the top contact wire to the low voltage wire marked
"HOT 1" with a wire nut.
7: Connect the middle contact wire (coming out of the
cylindrical connector) to the low voltage wire marked
"HOT 2" with a wire nut.
8: Connect the remaining side wire to the low voltage wire
marked "COM" with a wire nut.
NOTE: Use the universal round crossbar (provided) if the electrical
box holes are not spaced 2-3/4" apart.
NOTE: The low voltage wires should be present in the electrical
box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.
HOT 1
HOT 2
COM
MIDDLE CONTACT WIRE
TOP CONTACT
WIRE
SIDE WIRE
6
8
7
CYLINDRICAL
CONNECTOR
© 2009 Edge Lighting. All Rights Reserved.