Edge Lighting Sloped Ceiling Surface Mount Magnetic Transformers - Manual (Page 2)

2
Install the Surface Mount Transformer
4: Connect the provided white and black extension wires to the
neutral and hot power wires respectively with the wire nuts
provided.
5: Feed the wires through the crossbar assembly nipple.
6: Place all wires and wire nut connections inside the electrical
box.
7: Mount the crossbar assembly to the electrical box with the
two provided #8-32 screws.
8: Make sure the crossbar assembly is grounded in accordance
with local electrical codes.
#8-32 SCREW
CROSSBAR ASSEMBLY
NIPPLE
4
7 5
EXTENSION WIRES
D
8
6
4
3: Remove the inside nut and washer to remove the crossbar
assembly. DO NOT DISASSEMBLE THE CROSSBAR
ASSEMBLY.
1: Loosen and remove the five M4 button head screws around
the transformer cover with the provided 2mm Allen wrench. A
2: Unhook the transformer cover from the set screw and
remove it from the transformers housing.
COVER
1 1
1
2MM ALLEN WRENCH
C CROSSBAR
ASSEMBLY
WASHER
INSIDE NUT
3
M4 BUTTON HEAD SCREW
3
B
HOUSING
SET SCREW
2
9: Feed the extension wires through the transformer housing
center hole. Slide the transformer housing onto the crossbar
assembly nipple and secure it in place by tightening the
washer and inside nut.
E
CROSSBAR ASSEMBLY
NIPPLE
EXTENSION WIRES
HOUSING WASHER
INSIDE NUT
9
COVER
NOTE: To resize the power feed rod, refer to “Shortening
The Power Feed Rod Height” on Page 5 before continuing
with the steps below.