Edge Lighting 4" Round Adjustable Power Feed Canopies - Manual (Page 2)

MONORAIL
2
C
8
3/32 ALLEN
WRENCH
8
#8-32
SCREW
7: Place all wires inside the electrical box.
8: Secure the power feed canopy to the electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
Install the Power Feed Canopy
Wires to Monorail
D
1: Unscrew the cap from power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE THEM
E
3: Place the Monorail into the power housing. Make sure that
the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.
4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.
F
5: Tighten the 3/8-24 set screw on the cap firmly with the 3/16
Allen wrench for proper power connection.
G
6: If the power feed wires are sagging, loosen the two M4 set
screws on the plastic disk with the 2 mm Allen wrench.
7: Push the power feed wires into the canopy and tighten the
two M4 set screws with the 2mm Allen wrench.
2MM ALLEN WRENCH
M4 SET SCREW
PLASTIC DISK
6
7
CAP
POWER HOUSING
2
1
POWER HOUSING
CAP
3
4
CAP
3/8-24 SET SCREW
5
3/8-24 SET SCREW
3/16 ALLEN WRENCH
3/16 ALLEN WRENCH