Edge Lighting 4" Round Adjustable Power Feed Canopies User Manual
Install the canopy, Installation instructions for, Important information

SAVE THESE INSTRUCTIONS!
MP-4RD-A-_
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
Installation Instructions for
Monorail 4" Round Single Power Feed Canopy
With 12' Adjustable Power Feed Wires
1
904-MP-4RD-A-04
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
A
Install the Canopy
2MM ALLEN WRENCH
M4 SET SCREW
POWER CORD
1: Loosen the two M4 set screws on the plastic disk with the
2mm Allen wrench provided.
2: Adjust the power feed wires to the desired height (from top
of the canopy to top of the Monorail - illustrated as "H" in
diagram A) by pushing the power feed wires into the canopy.
3: Tighten the two M4 set screws firmly with the 2mm Allen
wrench.
4: Leave at least 6" of the power feed wires behind the canopy.
Trim off the excess power feed wires with a sharp cutter.
PLASTIC DISK
B
1
3
2
5: Turn the power to electrical box off.
6: Strip 1/4" of insulation off of the power feed wires and
connect each low voltage wire coming from the remote
transformer to one power feed wire with a wire nut.
NOTE:
Use the universal round crossbar (provided) if the electrical
box holes are not spaced 2-3/4" apart.
NOTE:
The low voltage wires should be present in the electrical
box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.
4
6
6
H
© 2009 Edge Lighting. All Rights Reserved.