Edge Lighting Outlaw - Manual (Page 3)

3
12: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail 2
Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).
13: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.
CIRCUIT #1 CIRCUIT #2
1
2
N
1
2
N
H
12
12
12
12
12
12
13
13
10: Make sure the strain relief tube is completely into the
coaxial fixture connector and the slot on the strain relief
tube is not inline with the M4 set screw.
11: Tighten the M4 set screw with the 2mm Allen wrench.
G
10
11
2MM ALLEN WRENCH
M4 SET SCREW
STRAIN RELIEF TUBE
COAXIAL FIXTURE
CONNECTOR
F
1.5MM ALLEN WRENCH
M3 SET SCREW
OUTER METAL JACK INNER WIRE
8
8: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip.
9: Hold the fixture connector and coaxial cable in place.
Replace and tighten the M3 set screw on fixture connector
tip with the 1.5mm Allen wrench.
9