Edge Lighting Bloom - Manual (Page 3)

3
14: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail 2
Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).
15: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.
CIRCUIT #1 CIRCUIT #2
1
2
N
1
2
N
J
14
14
14
14
14
14
15
15
12: Make sure the strain relief tube is completely into the
coaxial fixture connector and the slot on the strain relief
tube is not inline with the M4 set screw.
13: Tighten the M4 set screw with the 2mm Allen wrench.
I
12
13
2MM ALLEN WRENCH
M4 SET SCREW
STRAIN RELIEF TUBE
COAXIAL FIXTURE
CONNECTOR
H
1.5MM ALLEN WRENCH
M3 SET SCREW
OUTER METAL JACK INNER WIRE
10
11
10: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip.
11: Hold the fixture connector and coaxial cable in place.
Replace and tighten the M3 set screw on fixture connector
tip with the 1.5mm Allen wrench.