Yealink SIP-T48G - Manual (Page 138)

User Guide for the SIP-T48G IP Phone
128
To configure the transfer mode via DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode Via
Dsskey. Depending on your selection:
- If you select Blind Transfer, tap the BLF key to blind transfer the call to the
monitored phone number.
- If you select Attended Transfer, tap the BLF key to dial out the monitored phone
number. Then you can perform the attended or semi-attended transfer.
- If you select New Call, tap the BLF key to place a new call to the monitored user.
3. Click Confirm to accept the change.
Note
You can record calls by tapping a record key on the phone. The SIP-T48G IP phone
supports record and URL record.
Two ways of call recording:

Record: The phone sends a SIP INFO message containing a specific header “Record:
on/off” to trigger a recording.

URL Record: The phone sends an HTTP URL request to trigger a recording. Contact
your system administrator for the predefined URL.
Note Call record is not available on all servers. Contact your system administrator for more
information.
Transfer mode via DSS key is configurable via web user interface only.