Yealink W52H - Manual

Call Hold and Resume
To place a call on hold:
To resume a call, do one of the following:
If there is only a call on hold, press the Resume soft key.
Press the Options soft key during a call, and select Hold.
If there are two calls on hold, press the Resume soft key to resume the current call,
press the Swap soft key to swap between the two calls.
For more information, refer to the User guide available online at:
http://www.yealink.com/DocumentDownload.aspx?CateId=142&flag=142.
Copyright 2013 YEALINK NETWORK TECHNOLOGY CO.,LTD. c
Semi-Attended Transfer
Attended Transfer
Call Forward
Blind Transfer
Call Transfer
You can transfer a call in the following ways:
1. Press the Options soft key during a call, and select Blind Transfer.
1. Press the Options soft key during a call, and select Transfer.
1. Press the Options soft key during a call, and select Transfer.
2. Enter the number you want to transfer the call to.
3. Press the Transfer soft key to dial out.
To enable the call forward feature on a specific line:
Always----Incoming calls are forwarded immediately.
Busy----Incoming calls are forwarded when the handset is busy.
No Answer----Incoming calls are forwarded if not answered after a period of time.
1. Press the OK key to enter the main menu, and select Call Features->Call Forward.
3. Press or to highlight the desired forwarding type, and press the OK soft key.
5. Enter the number you want to forward the incoming calls to in the Target field.
7. Press the Save soft key to accept the change.
2. Enter the number you want to transfer the call to.
4. Press the Transfer soft key when you hear the ring-back tone.
3. Press the Transfer soft key.
2. Enter the number you want to transfer the call to.
3. Press the Transfer soft key to dial out.
4. Press the Transfer soft key after the call is answered.
2. Press or to highlight the desired line, and press the OK soft key.
4. Select Enabled from the Status field.
6. Press or to select the desired ring time to wait before forwarding (only for No
Answer Forward) in the After Ring Time field.
Call Mute
Press during a call to mute the call.
Press again to un-mute the call.
Quick Reference Guide
www.yealink.com
Configuring your Phone
W52P & W52H
IP DECT Phone
Applies to firmware version 30 or later.