Bio-Rad PROTEAN II XL Cell - Manual (Page 3)

i
Note
To insure best performance from the PROTEAN ® II xi cell, become fully acquainted with these operating
instructions before using the cell to separate samples. Bio-Rad recommends that you first read these
instructions carefully. Then assemble and disassemble the cell completely without casting a gel. After these
preliminary steps, you should be ready to cast and run a gel.
Bio-Rad also recommends that all PROTEAN II xi cell components and accessories be cleaned with a
suitable laboratory cleaner (such as Bio-Rad Cleaning Concentrate, catalog #161-0722) and rinsed
thoroughly with distilled water, before use.
Model
Catalog No.
Date of Delivery
Warrant Period
Serial No.
Warranty
Bio-Rad Laboratories warrants the PROTEAN II xi cell against defects in materials and workmanship for 1 year.
If any defects occur in the instrument during this warranty period, Bio-Rad Laboratories will repair or replace
the defective parts free. The following defects, however, are specifically excluded:
1. Defects caused by improper operation.
2. Repair or modification done by anyone other than Bio-Rad Laboratories or an authorized agent.
3. Use of fittings or other spare parts supplied by anyone other than Bio-Rad Laboratories
4. Damage caused by accident or misuse.
5. Damage caused by disaster.
6. Corrosion due to use of improper solvent or sample.
7. This warranty does not apply to parts listed below:
• Platinum wire
• Glass plates
For any inquiry or request for repair service, contact Bio-Rad Laboratories after confirming the model and
serial number of your instrument.
Nonidet is a trademark of Shell International Petroleum Company. Parafilm is a trademark of American National Can
Company. Triton is a trademark of Dow Chemical Company. Tygon is a trademark of Norton Company.