Great Plains ADC2220 Predelivery Manual - Manual (Page 36)

167-088Q-RUS 3/3/2006
ADC2220 & NTA 3510 34
24115
24116
Figure 70
Align Parallel Arms with Frame
Figure 71
Bolt Parallel Arms to Frame
Figure 72
Gauge Wheel
24117
Refer to Figure 70
14. Align parallel arm assembly with frame. Top
set of parallel arms align with top hole of frame
and pivot bolt holder. NOTE: Make sure to bolt
parallel arm assembly to frame with eyebolt
weldment on top.
Refer to Figure 71
15. Insert bolt removed in step 11 through pivot
bolt holder, frame, and parallel arm lift assem-
bly.
16. Secure with hardware removed in step 11.
17. Repeat steps for installing parallel arm lift as-
sembly on opposite side of the implement.
Parallel Arm Dual Gauge Wheels
Refer to Figure 72
1. Remove tape from gauge wheel.
2. Remove caster retainer cap and pivot thrust
washer from gauge wheel.
24138
Frame
Parallel Arms