Great Plains ADC2220 Predelivery Manual - Manual (Page 10)

167-088Q-RUS 3/3/2006
ADC2220 & NTA 3510 8
Pre-Assembly
The following headings are step-by-step instructions
for assembling the cart. Begin with Tools Required
and Pre-Assembly Checklist to make sure you have
all necessary parts and equipment. Then proceed
with Unload Center Section Rack. Follow each step to
make the job as quick and safe as possible and pro-
duce a properly working machine.
It is the dealer’s responsibility to unload the new ma-
chine. Unload all equipment before beginning assem-
bly. Do not attempt any assembly work while the cart
is on the truck.
Tools Required
•
Forklift or overhead hoist with 8,000-pound capaci-
ty
•
Hand jack with 4-ton capacity
•
General hand tools
•
Jack stands, blocks and safety chain
Pre-Assembly Checklist
1. Read and understand “Important Safety Infor-
mation” on page 1 before assembling.
2. Have at least two people on hand while assem-
bling.
3. Make sure the assembly area is level and free of
obstructions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with cart.
6. Have a copy of the parts manual on hand. If un-
sure of proper placement or use of any part or
fastener, refer to the parts manual.
7. Check that all working parts are moving freely,
bolts are tight, and cotter pins are spread.
8. Check that all safety labels and reflectors are cor-
rectly located and legible. Replace if improperly
located or damaged. Refer to Safety Labels, “Im-
portant Safety Information” in the operator’s
manual.
9. Inflate tires to recommended pressure as listed
on the Tire Inflation Chart on the “Appendix” on
page 49. Tighten wheel bolts as specified on
Torque Values Chart on the “Appendix” on page
49.
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.
Unload Center Section Rack
!
DANGER!
Crushing hazard. You may be severely injured or killed by
the cart if it falls. Secure cart to lifting equipment so it can-
not fall. Do not walk or place any body part under the
raised sections of the cart.
NOTE: The air drill cart and air drill implement are
shipped on racks via containers.There are three
racks total: the wing rack, the center section rack, and
the bins rack.
Refer to Figure 1
1. Unload the center section rack first. Remove as
many loose pieces as possible from rack. Keep
pieces separate.
23429
Figure 1
Center Section
23492
Figure 2
Remove Walkboard Handrails
Refer to Figure 2
2. Unbolt walkboard rails from rack.