Great Plains YP Fertilizer System - Manual (Page 6)

Great Plains Mfg., Inc.
6 Fertilizer System
407-197M 02/29/2008
Refer to Figure 8
21. Using a hoist or lift, position the U-bolt plate of the
cradle against the rear face of the right end of the
mainframe tool bar
.
22. Loosely install the U-bolts , washers (not
shown in photo) and nuts (not shown in photo).
23. Adjust the position of the cradle as far to the right
(outside) as possible. Tighten the nuts.
24. Select the right shut-off/clean-out assembly .
Operate the valve handle to the closed position. After
installation, the handle needs to be down in this posi-
tion. Rotate the handle to open.
25. Apply sealant to the male threads of the forward
adaptor . Thread the fitting assembly into the
tank elbow. Adjust final rotation to place valve handle
to correct side so that handle closed will be down.
Install Tank Interconnect Fittings
Refer to Figure 9
26. Select sets of mounting hardware, consisting of
(quantities are for both sets):
27. Disassemble one of the clamps.
Refer to Figure 10
28. At each lower front corner of the seed box manifold,
remove and save the existing:
29. Attach the bare bracket to the front lower left
corner of the manifold, using the saved fasteners.
30. Attach the still-assembled other bracket to the
front lower right corner of the manifold, using the
saved fasteners.
Figure 8
Right Tank Cradle Mount
27090
2
115
5
115 114
110
R
136
Qty Call Part Description
2 506-365D WET BOOM FLAT HOSE BRACKET
2 890-522C MUFFLER CLAMP 2.50 SIZE (which
includes the bracket, U-bolt and nuts)
U
D
F
B
L
R
Figure 9
Tank Interconnect Mounts
27104
120
148
120
148
Qty Call Part Description
2 802-078C HHCS 1/4-20X5/8 GR5
2 803-006C NUT HEX 1/4-20 PLT
2 804-006C WASHER LOCK SPRING 1/4 PLT
U
D
F
B
L
R
Figure 10
Interconnect Mount Points
27104
11
13 12
120
11
12
13
120
120