Great Plains YP Fertilizer System - Manual (Page 4)

Great Plains Mfg., Inc.
4 Fertilizer System
407-197M 02/29/2008
Install Left Tank Elbow
Refer to Figure 4
7.
Select the left shut-off/clean-out assembly , con-
sisting of:
8. Remove the elbow (which is only loosely pre-
assembled to the fittings).
9. Select and open the can of sealant
10. Apply sealant to the male threads of the elbow ,
and thread it into the 1
1 ⁄
2
in FNPT bulkhead at the
bottom of the tank. Close can when not in use.
Refer to Figure 5
11. Using a hoist or lift, position the U-bolt plate of the
cradle against the rear face of the left end of the
mainframe tool bar
.
12. Loosely install the U-bolts , washers (not
shown in photo) and nuts (not shown in photo).
13. Adjust the position of the cradle as far to the left (out-
side) as possible. Tighten the nuts.
14. Select the left shut-off/clean-out assembly . Oper-
ate the valve handle to the closed position. After
installation, the handle needs to be down in this posi-
tion. Rotate the handle to open.
15. Apply sealant to the male threads of the forward
adaptor . Thread the fitting assembly into the
tank elbow. Adjust final rotation to place valve handle
to correct side so that handle closed will be down.
Qty Call Part Description
1 830-052C EL 1 1/2MNPT X 1 1/2FNPT POLYP
2 830-045C AD 1 1/2MNPT POLYPROP
1 829-013C VALVE 1 1/2FNPT BALL POLYPROP
1 830-031C TEE 1 1/2FNPT POLYPROP
1 830-024C PL 1 1/2MNPT POLYPROP
1 830-094C AD 1 1/2MNPT X 1 1/2HB POLYP
Qty Call Part Description
1 890-310C RECTORSEAL 21 BLK THD SEALANT
U
D
F
B
L
R
Figure 4
Left Tank Fittings
27086
137
131
136
135
134
136
138
L
L
137
136
131
135
134
138
137
147
137
Figure 5
Left Tank Cradle Mount
27089
5
115
5
115 114
110
L
136