Install strainer mount, Install ground drive assembly, Refer to figure 20 – Great Plains YP Fertilizer System User Manual
Page 11
Great Plains Mfg., Inc.
Installation Instructions
11
02/29/2008
407-197M
Install Strainer Mount
Refer to Figure 20 (shown without strainer for clarity)
55. Make sure that at least two of the four slotted holes
in the mount
can be aligned with holes at your
intended mounting point (in this illustration, the left
side of the inboard plate
of the left wing drive shaft
bracket).
Mount
is intended to place with the short bent
end to planter rear and facing away from the mount-
ing surface.
56. Insert each bolt
end through at least two of the
four holes in the mount
and the frame plate
57. Add the removed flat washer
, lock washer
and nut
to each bolt and finger tighten.
58. Hand-position valve/strainer assembly to determine:
• mounting clearance,
• hose clearance,
• operator access,
• clearance for valve operation,
• preferred inlet elbow orientation, and
• clearance for strainer maintenance.
59. Adjust mount
to provide suitable final position
and tighten bolts/nuts.
Install Ground Drive Assembly
Refer to Figure 21, which depicts the ground drive with guards
removed. Guards may be left in place until final sprocket mounting.
60. Select:
61. Position the two U-bolts
over the tool bar
at
the mount location.
62. Use a hoist or lift to hold the drive assembly
at
the mount point. Insert the U-bolts
. Tempo-
rarily hold the assembly in place with four nuts
(not shown in figure).
63. Remove one nut
at a time. Place a flat washer
(not shown), lock washer
(not shown) and
nut
on the U-bolt. Tighten each until the drive
assembly’s mount is flat against the tool bar.
Tighten to torque spec.
Qty
Call
Part
Description
1
407-146K FERTILIZER PUMP DRIVE
4
806-102C U-BOLT 3/4-10 CORNER 7 SQ
4
804-025C WASHER FLAT 3/4 SAE PLT
4
804-023C WASHER LOCK SPRING 3/4 PLT
4
U
D
F
B
L
R
Figure 20
Install Strainer Mount
25305
1
1
U
D
L
R
B
F
Figure 21
Install Ground Drive
25307
1