Great Plains NTA3010 Predelivery Manual - Manual (Page 39)

Great Plains Manufacturing, Inc. Setup 37
11/06/2008 160-220M
Install Press Wheels
To meet highway clearance requirements, the press
wheel arms and wheels on rear wing rows are not fac-
tory-installed.
Start with the left end of the left wing.
84. Select one each:
Arm and press wheel assembly (exact part
number vary, depending on drill row option)
198-137D PRESS WHEEL PIVOT TUBE
and two:
817-084C PARALLEL ARM PIVOT BUSHING
Insert the bushings in each side of the arm pivot.
Insert the pivot tube in the bushings.
85. Select one each:
802-421C HFS 1/2-13X3 3/4 GR5 SPTHD
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
Align the press wheel assembly with the pivot
hole in the opener frame. Secure with bolt and
lock nut .
86. Repeat step 84 and step 85 for each rear wing row.
Install Options
Blockage Detectors
Blockage detectors are not factory-installed, as they are
mounted after the secondary hoses are installed. Install
them now per the instructions supplied with the blockage
detector kit.
Other Options
If any of the following were ordered with the drill, they are
factory-installed. If they were ordered as separate field-
install kits, install them now:
• Coulter Tines
• Seed Firmers
Figure 48
Typical Press Wheel Assembly
28205
34
40
60
60
44
1
1
34
60
60
34
40
44
1
40
44