Great Plains NTA3010 Predelivery Manual - Manual (Page 33)

Great Plains Manufacturing, Inc. Setup 31
11/06/2008 160-220M
Refer to Figure 42
76. Select one:
816-352C AIR DRILL DD OPNR HOSE BOOT
77. Connect hose boot to hose by screwing hose
into hose boot
78. Connect to the seed tube by pushing the boot over
the lip of the seed tube .
79. Repeat step 70 through step 78 for each Port on the
current Tower, working clockwise around the tower.
80. When hoses have been installed in all ports,
retighten bolts on the tower assembly to secure
hoses.
81. Repeat step 70 through step 80 for each Tower,
moving right. When all hoses have been installed,
check that seed hoses are long enough for wing flex
and short enough to prevent hose damage. Hoses
may need to be removed, shortened and re-inserted.
Figure 42
Hose to Seed Tube
26436
1
59
58
58
58 59
1