Great Plains NTA3010 Predelivery Manual - Manual (Page 16)

14 NTA3010, NTA3510 and ADC Great Plains Manufacturing, Inc.
160-220M 11/06/2008
Assemble Lift-Assist-Wheel Arms
Un-Stow Arms
Rear parallel arms are folded forward for shipment.
Start with the left assembly.
Refer to Figure 11
38. Remove and save top nut, lock washer, spacer and
bolt:
803-031C NUT HEX 1-8 PLT
804-027C WASHER LOCK SPRING 1 PLT
161-246D NTA CASTER ARM SPACER TUBE
802-638C HHCS 1-8X12 1/4 GR8
These hold the folded arms on implement.
39. Use forklift or hoist to unfold arms and caster mount-
ing.
40. Insert the spacer in upper parallel arm and
secure upper arm to implement with saved bolt ,
lock washer and nut .
41. Repeat step 38 through step 40 for the right lift-
assist assembly.
Mount Wheels on Casters
Refer to Figure 12
There are two assemblies and four wheels.
42. At the caster assemblies:
161-116K NTA35 DUAL CASTER WHEEL ASSY
remove and save 12 caster wheel bolts:
802-104C BOLT WHEEL 1/2-20X1 90-DEG
IMPORTANT !
Do not mix bolts. Although all wheel bolts are 1 ⁄
2
-20
thread, lift-assist caster wheel bolts and rockshaft
wheel bolts are not identical.
43. Support caster weldments with hoist. Mount wheels
on hubs.
IMPORTANT !
Bolt wheels with edge of center dish in toward hub as
shown in Figure 12. Otherwise, wheels will be too wide.
44. Insert bolts and tighten to torque specification.
Figure 11
Rear Lift Assist Arm
28456
43
30
46
41
25
43
46
30
41
30 25
41
46 43
Figure 12
Lift-Assist Wheel Mounting
16199
37
15
24
24
37
37
39
15
37