Great Plains 3S-4010HDF Operator Manual - Manual (Page 39)

Great Plains Manufacturing, Inc. Operating Instructions 35
03/28/2012 196-522M
Parking
Following these steps when parking the drill for periods
of less than 36 hours. For longer periods, see Storage,
the next topic.
1. Position the drill on firm, level ground.
Roll-Away Hazard:
Do not unhitch on a slope.
2. Raise the drill.
3. Install lift locks.
4. Fold as necessary for the parking space available.
5. Securely block drill tires to prevent rolling.
6. Dismount jack from storage stob and pin to mount on
side of hitch. If ground is soft, place a board or
masonry block under jack.
7. Extend jack until tongue weight is off tractor drawbar.
8. Disconnect hydraulic lines, and arrange them so they
cannot contact the ground.
9. Disconnect electrical connections.
10. Remove hitch pin.
11. Remove safety chain.
Storage
Store the drill where children do not play. If possible,
store it inside for longer life.
1. Perform the drill Parking checklist.
2. Lubricate the drill at all points listed under “Lubrica-
tion” on page 75.
3. Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
4. Check all moving parts for wear or damage. Make
notes of any parts needing repair before the next
season.
5. Plug or cap seed delivery tubes to prevent pest entry.
6. Grease exposed cylinder rods to inhibit rust.
7. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
End of “Operating Instructions”
FigureSpacer:
FigureSpacer:
FigureSpacer:
Roll-Away Hazard:
Block tires when unhitching. Do not park on slopes.
Tongue weight at jack is not sufficient to anchor drill.
Always remove safety chain last.
Figure 39
Jack in Parking Position
20273