Great Plains 3S-4010HDF Operator Manual - Manual (Page 108)

104 3S-4010HD and 3S-4010HDF Great Plains Manufacturing, Inc.
196-522M 03/28/2012 E
Remove Rear Caster Transport Bolts
To prevent caster rotation during unloading, casters are
locked in their full reverse position with shipping bolts.
Refer to Figure 102
8.
At each rear caster, remove one set:
802-065C HHCS 3/4-10X2 1/4 GR5
804-093C WASHER FLAT 3/4 HARD ASTMF436
The removed parts may be stored on the shipping
clamps (if any).
FigureSpacer:
Install Wing Press Wheels
To meet highway clearance requirements, the press
wheel arms and wheels on wing rows are not factory-
installed.
Refer to Figure 103
Start with the left end of the left wing.
9. Select one each:
Arm and press wheel assembly (exact part
number varies, depending on drill row option)
198-137D PRESS WHEEL PIVOT TUBE
and two:
817-084C PARALLEL ARM PIVOT BUSHING
Insert the bushings in each side of the arm pivot.
Insert the pivot tube in the bushings.
10. Select one each:
802-421C HFS 1/2-13X3 3/4 GR5 SPTHD
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
Align the press wheel assembly with the pivot
hole in the opener frame. Secure with bolt and
lock nut .
11. Repeat step 9 and step 10 for each wing row.
FigureSpacer:
Figure 102
Gauge Wheel Caster Lock Bolt
29222
11
16
11
16
FigureSpacer:
Figure 103
Typical Press Wheel Assembly
28205
17
18
20
20
19
1
1
17
20
20
17
18
19
1
18
19