ClearOne Interact Serial Command Guide - Manual (Page 54)

Page 49 of 56
SYSRESULT – System Check Result
This command reports the results of the system check. This command is reportable only. It cannot be
queried or set.
ARGUMENT DETAILS
Name Type Size Values
System
Check
Hexadecimal 2
0 = Box 1 (mics A1-3)
1 = Box 2 (mics B1-3)
2 = Box 3 (mics C1-3)
3 = Speaker
4 = Telephone
5 = Network
6 = USB
All other bits reserved.
Status
Unsigned
Integer
2
0 = Fail
1 = Pass
Message String 40
For the Break Out Boxes: this message will say if a box is not
connected.
If a box is connected, the message will say which microphones
fail. If none fail, the message will say that all microphones pass.
For the speakers: the message will say if the speakers fail. If they,
pass but are out of phase, the message will say they are out of
phase. Otherwise, the message will say the speakers pass.
For the telephone on hook: the message will report the line
voltage, the line current, other results, and if dial tone is detected.
For the telephone off hook: the message will report the line
current, other results, and if dial tone is detected.
The bit mask for the other results is
xxxx xxxx
| | | | | | | |--> set if switched from CTR21 to FCC because of
low current
| | | | | | |--> set if used DIAL bit while dialing
| | | | | |--> set if switch from Low Voltage to Japan because of
current
| | | | |--> set if switch from Low Voltage to FCC because of
current
| | | |--> DAA OVL status
| | |--> DAA DOD status
| |--> DAA OPD status
|--> Not used
For the network check: the box will report if no IP address is set. If
it is set, the box will ping the gateway. The message will say the
ping failed if it is not returned in 5 seconds. Otherwise, the
message will report how many seconds it took to return the ping.
TEXT FORM DETAILS
COMMAND FORM:DEVICE SYSRESULT