SARGENT FM8700 Surface Vertical Rod Exit Device - Manual (Page 22)

Ground ring terminal
4, Green (EG)
8
7 6
5 4
3 2
1
1, Black (-Return)
2, Red (+24)
3, White RR
5, Orange (EI)
6, Blue (DS)
7, Brown (RAR - C)
8, Yellow (RAR - NO)
4
3
2
1
Red/Green (Gang - C)
Red/Yellow (Gang - NO)
Red/Black (Gang - NC)
1, Violet (RAR - NC)
2, Grey (LBM - C)
3, Pink (LBM - NO)
4, Tan (LBM - NC)
Electroguard (59-, 12-59-)
80 Series Rail
with 8 and 4-pin connectors
and 3 flying leads
Note: RAR, LBM and Gang contacts
shown are with power applied to rail
Electroguard™ Wiring
A. IMPORTANT
Caution: Disconnect all input power before beginning installation to prevent electrical
shock and equipment damage
1. Installer must be a trained, experienced service person
2. All wiring must comply with applicable local electrical codes, ordinances and regulations
3. Field cut rail assemblies are not allowed. Exit device must be ordered for specific door width.
Legend
LBM = Latchbolt Monitor
RAR = Remote Alarm Relay
Gang = Gang Release
EI = External Inhibit
DS = Door Status Switch
EG = Earth Ground
NO = Normally Open
NC = Normally Closed
RR = Remote Reset
C = Common
7
B. Installation Notes:
1. With new applications, a raceway harness with 8 & 4-pin connectors will be pre-installed inside the door by
ASSA ABLOY door manufacturer when specified during the ordering process. Raceway harness kits are also available
for retrofit applications. (For retrofit applications, refer to retrofit instructions)
2. If door does not have a raceway harness with connectors, either consult factory for raceway retrofit kit or cut
connectors off product and hard wire, as required.
3. Wiring to pigtail harness is per facility wiring requirement.
The rail, raceway, electric hinge and pigtail connector ( - +) terminations and wire colors all match.
22 1-800-810-WIRE • www.sargentlock.com • A7690E
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/15/13
Electroguard ® 59- Prefix 80 Series Exit Device