SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 3)

1
A7856B • 800-810-WIRE (9473) • www.sargentlock.com
Profile Series v.G1.5 Exit Device
0
5
/0
4
/0
9
A
7
8
5
6
:B
C
o
p
yr
ig
h
t
©
2
0
0
9
,S
a
rg
e
n
t
M
a
n
u
fa
c
tu
ri
n
g
C
o
m
p
a
n
y,
a n
A
S
S
A
A
B
LO
Y
G
ro
u
p
c o
m
p
a
n
y.
A
ll
ri
g
h
ts
re
se
rv
e
d
.
R
e
p
ro
d
u
c ti
o
n
in
w
h
o
le
o
r
in
p
a rt
w
it
h
o
u
t
th
e
e
xp
re
ss
w
ri
tt
e
n
p
e
rm
is
si
o
n
o
f
S
A
R
G
EN
T
M
a
n
u
fa
c tu
ri
n
g
is
p
ro
h
ib
it
e
d
.
The SARGENT Profile Series v.G1.5 Rim/Mortise Exit Device is designed for areas which require stand alone
authorized entry. It is a self-contained microprocessor-controlled keypad with non-volatile memory. The keypad will
hold a total of 100 (LK)/2000 (GI-LU, GI-PK, GI-PA, G1-TU, G1-TP, G1-TA) different user codes. User locations “01”
& “02” are utilized for Master and Supervisory Codes, respectively.
This product is operated by six (6) “AA” alkaline batteries. SARGENT exit devices locks are designed with high
quality components to provide high security, performance and durability.
General Description 2
!
Specifications
Profile Series Rim Exit
• Latch – 3/4" throw, stainless steel
• Outside motor driven “ET” lever controlled by keypad
• Push bar retracts latch from inside
• Fire stop provided on all lever handle designs
• Profile Series exit devices furnished for 1-3/4" doors
• UL Listed
• Accepts all SARGENT rim cylinders (8877 only)
• Key retracts latch (8877 only)
• Available in “ET” lever handle designs only
Profile Series Mortise Exit
• Latch – 3/4" throw, anti-friction, brass
• Outside motor driven “ET” lever controlled by keypad
• Push bar retracts latch from inside
• Fire stop provided on all lever handle designs
• Profile Series exit devices furnished for 1-3/4" doors
• UL Listed
• Accepts all SARGENT mortise cylinders (8977 only)
• Key retracts latch (8977 only)
• Available in “ET” lever handle designs only
Features
• Low battery alert – 4 chirps after code entry
• External remote “request to enter” connector
• Master, Emergency or Supervisory code will unlock door
when low battery has expired
• Programming done at keypad or with a PDA using
SofLink™ Plus software and a PC (software required for
G1-PA & G1-TA)
• Entry of three wrong User Codes disables all codes for
ten seconds. Yellow LED on solid
• Last 15 transactions can be output to portable printer
via infrared link (LK Only)
• Last 2000 (Except LK) transactions can be output to
PC using a PDA and SofLink™ Plus software
3
4
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced TV technician for help
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme avec la norme NMB-003 du Canada.
Warning 1 Warning: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Warning
To comply with “Fire Listed” doors, the batteries must be replaced with alkaline batteries only.