Profile series v.g1.5/lk mortise lock – SARGENT Profile Series v.G1.5 Mortise Locks User Manual

Page 11

01/31/14

1-800-810-WIRE • www.sargentlock.com • A7855C 11

t Manufacturing Company

, an A

A AB

Y G

roup company

. All right

s reser

ved

Reproductions in whole or in par

t without express writ

ten permission of Sargen

t Manufacturing Company is prohibited

Profile Series v.G1.5/LK Mortise Lock

1. Slide lever handle onto spindle

until fully seated (Fig. 8A).

2. Insert #8-32 x 1-1/4” screws through inside

escutcheon and thread into outside escutcheon.

3. Straighten escutcheons and tighten securely.
4. Tighten the set screw securely with 1/8” hex

wrench.

Step #8 – Inside Lever Installation

Step #9 – Install and Secure Cylinder

1. Slide cylinder through the spring and rosette/collar

and screw into lock body, rotating the cylinder clockwise (Fig. 9A).

Cylinder should be flush with rosette/collar.
Note: The 43 cylinder may be used when installing

this product with or without a gasket.
Note: SARGENT logo must be horizontal and

on the top of the cylinder (Fig. 9B).

2. Secure the cylinder by tightening cylinder clamp

screw located above the deadbolt using #2

Phillips screwdriver (Fig. 9C).

3. Using the key, test cylinder functions:

• 8278 Function: Key retracts latch
• 8276 Function: Key retracts

latch and projects and

retracts deadbolt

Fig. 9B

Position cylinder so that the

SARGENT logo is right-side up.

Correct Incorrect

Fig. 9C

Outside of Door

Cylinder Clamp Screw

#2 Phillips
Screwdriver

Fig. 9A

Outside of Door

Key

Type 43 Cylinder

Inside of Door

Fig. 8A

Spindle

Set Screw

Inside Lever