SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 8)

6
For installation assistance, contact SARGENT at 800-810-WIRE (9473)
Enter a Lock Out User Code
99# Master Code* Yellow LED blinks
50# 3# (User Location 04-2000)# Yellow LED blinks
User Code* Yellow LED blinks quickly
User Code* Yellow LED blinks slowly (If solid, see note)
* Yellow LED goes out
Note: The "lock out" user is location dependent. To ensure that all users are locked out of the keypad,
program this user at "user location" #4.
Enter A One Time User Code
99# Master Code* Yellow LED blinks
50# 5# (User Number 04-2000)# Yellow LED blinks
User Code (1-6 Digits)* Yellow LED blinks quickly
User Code (1-6 Digits)* Yellow LED blinks slowly (If solid, see note)
* Yellow LED goes out
Enter An Extended Unlock User Code
99# Master Code* Yellow LED blinks
50# 4# (User Location 04-2000)# Yellow LED blinks
User Code (1-6 digits)* Yellow LED blinks quickly
User Code (1-6 digits)* Yellow LED blinks slowly (If solid, see note)
* Yellow LED goes out
Enter a Card, Tag, Fob and RF Fob User
99# Master Code* Yellow LED blinks
50# Yellow LED blinks
(Select only one number below, end it with a #, ie 4#)
0= Passage Code; 1= Standard User; 3= Lockout Code; 4= Extended Unlock User; 5= One Time User; 7= Emergency
Code; 8= Communications Enable; 9= Panic User
(Yellow LED blinks)
(User Number 04-2000)# Yellow LED blinks
* Yellow LED blinks Quickly
* Yellow LED blinks Slowly (if Solid See Note)
Present Card, Tag or RF Fob Beep / Yellow LED blinks
* Yellow LED blinks Slowly
* Yellow LED Goes Out
Enter a User Code + Card, Tag, FOB and RF Fob
99# Master Code* Yellow LED blinks
50# 1# (User Number 04-2000)# Yellow LED blinks
User Code (1-6 digits)* Yellow LED blinks quickly
User Code (1-6 digits)* Yellow LED blinks slowly (If solid, see note)
Present Card, Tag, Fob or RF Fob BEEP / Yellow LED blinks
* Yellow LED blinks slowly
* Yellow LED goes out
To Activate The RF FOB Function
Note: Press the button on the RF FOB. If the controller beeps and LEDs flash, this procedure does not have
to be done. RF enabled will shorten the battery life of the unit.
Press the reset button located in the battery compartment and any front key at the same time for 1 second, then
release buttons.
Yellow LED blinks slowly
Enter code 1030# Yellow LED blinks slowly
1# Yellow LED blinks slowly
1# Or (0# to disable The RF Function) Yellow LED blinks slowly
* Yellow LED blinks faster
* Yellow LED blinks slowly
* Yellow LED out
To Clear the Entire Memory
99# Master Code* Yellow LED blinks
46# 00000# 00000# Yellow LED blinks
* Yellow LED blinks quickly
* Yellow LED blinks very fast for 10 sec., then slow
* Yellow LED goes out
Keypad Programming Instructions for the Profile Series v. G1 Lock
© SARGENT Manufacturing Company