Tweco 200 ACDC Arcmaster(Feb2006) User Manual
Page 35

29
6.01 Stick Welding
•
Connect work lead to negative terminal
•
Connect electrode lead to positive terminal
•
Switch machine on
•
Set
AC
or
DC
weld current. If
AC
is selected then set
AC FREQ
to 60Hz &
WAVE BALANCE
to 50%
•
Set Contactor
•
Connect remote control device if required
Use the Scroll Buttons to move to the parameter to be set. The LED will show which function is being
adjusted on the weld sequence graph. Use the control knob to adjust
each parameter.
•
Set
HOT START
•
Set
WELD
current
Commence welding
6.02 AC or DC HF TIG Welding
• Connect work lead to positive terminal
•
Connect TIG torch to negative terminal
•
Switch machine on
•
Set
AC
or
DC
weld current. If
AC
is selected then set
AC FREQ
&
WAVE BALANCE
•
Connect remote control device if required
Use the Scroll Buttons to move to the parameter to be set. The LED will show which function is being
adjusted on the weld sequence graph. Use the control knob to adjust
each parameter.
•
Set
PRE-FLOW
time
•
Set
HOT START
current
•
Set
POST-FLOW
time
•
Set (WELD)
PEAK CUR
current
•
Set
POST-FLOW
time
Slope Mode Parameters if required
•
Set
INTIAL CUR
current
•
Set
UP SLOPE
time
•
Set (WELD)
PEAK CUR
current
•
Set
BASE
current
•
Set
DOWN SLOPE
time
•
Set
CRATER CUR
current
Pulse Mode Parameters if required
•
Set
PULSE WIDTH
% for
PEAK CURRENT
• Set PEAK CURRENT
•
Set
PULSE FREQ
Commence welding