Tweco SC-3000 User Manual
Sc-3000, Operating manual, Precision torch height control
Table of contents
Document Outline
- SECTION 1:GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- SECTION 2 SYSTEM:INTRODUCTION
- SECTION 3 SYSTEM: INSTALLATION
- SECTION 4 SYSTEM: OPERATION
- 4.01 Requirements and Check List for first Start-up
- 4.02 Power Up
- 4.03 OPERATOR TERMINAL Menu-Overview
- 4.04 OPERATOR TERMINAL SETTINGS
- 4.05 SIGNAL FLOW DURING PLASMA CUTTING
- 4.06 SC 3000 Operation Sequence
- 4.07 LOSS OF PLASMA ARC
- 4.08 DETECTION OF KERFS AND EDGES DURING CUTTING
- 4.09 SCRAP CUTTING
- 4.10 PROCEDURE WITH GAS PRE-FLOW
- 4.11 SC 3000 Torch Height Control (THC) Modes of Operation
- 4.12 Parameter Setting
- 4.01 Requirements and Check List for first Start-up
- SECTION 5 SYSTEM:SERVICE
- SECTION 6:PARTS LISTS
- APPENDIX 1: DEFINITIONS
- APPENDIX 2: GROUNDING A CUTTING MACHINE
- APPENDIX 3: POWER SUPPLY
- APPENDIX 4: INTERFACE
- APPENDIX 5: OPERATOR TERMINAL-REMOTE
- APPENDIX 6: CNC CONNECTIONS TO OTHER CONTROLLERS
- APPENDIX 7: CONTROLLER SCHEMATIC
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION