Tweco SC-3000 - Manual (Page 75)

SC-3000
Manual 0-5100 A-5 APPENDIX
APPENDIX 4: INTERFACE
The Interface is the central signal distribution point for the SC-3000™ System.
Art # A-08945
Features
• Power supply 24 VDC / 0.5A
• Connector to LINEAR DRIVE
• Connector to OPERATOR TERMINAL
• Interface for CUTBUS® used for serial communication to CNC
• Discrete Input / Output terminals 24 VDC to connect SC-3000™ to CNC-machine control system 2x17-remov-
able screw terminal strips. Special coding avoid mix-up.
• Integrated isolation amplifier for ARC voltage 0-10 VDC und 0-300 VDC from the plasma source
• 3 rotating switches to set
- Device address of Cutbus
- Baud rate for Cutbus
- optional range for ARC voltage
• LED’s for Ready, Communication and Fault
• Assembly on top hat rail for installation in a control cabinet
Technical Specifications
Input Voltage 24 VDC ±10%, with integrated reverse voltage protection
Input Plasma-ARC Voltage
Switch
setting
Input Voltage
range
Represents ARC
Voltage
Input resistance
0 0 to -300 VDC 0-300 VDC ca. 3 MOhm
1 0 to +10 VDC 0-300 VDC ca. 100 KOhm
2 0 to +6 VDC 0-300 VDC ca. 100 KOhm
3 0 to +10V 0-250VDC ca. 100 KOhm
Digital input of control signals 24 VDC ±10% / Resistor Ri ≈ 7 kOhm
Digital output of control signals 20 VDC / Resistor Ri ≈ 150 Ohm / short circuit proof