Tweco RC6010 - Manual (Page 13)

Manual 0-2478 9 INTRODUCTION & DESCRIPTION
SECTION 2:
INTRODUCTION &
DESCRIPTION
2.01 Scope of Manual
This manual contains descriptions, operating instructions
and maintenance procedures for the RC6010 Remote
Control Accessory. Service of this equipment is restricted
to Thermal Dynamics trained personnel; unqualified per-
sonnel are strictly cautioned against attempting repairs
or adjustments not covered in this manual, at the risk of
voiding the Warranty.
Read this manual thoroughly. A complete understand-
ing of the characteristics and capabilities of this equip-
ment will assure the dependable operation for which it
was designed.
2.02 General Description
The RC6010 Remote Control Accessory extends the nec-
essary system controls away from the power supply and
is provided with standard machine torch systems.
There are connections available at the Remote Control
Accessory for CNC control and Plasma Power Supply.
The inputs and outputs at these connections allow the
various parts of the system to be operated at one station.
Some of the functions of the Remote Control Accessory
may not operate depending on the Plasma Cutting Sys-
tem used.
All necessary cables are supplied for the type system or-
dered. If the RC6010 Remote Control Accessory is not
purchased as part of a system, the appropriate remote
control cable and a CNC cable (if required) must be or-
dered separately. Refer to Section 6, Parts Lists, for or-
dering information.
OUTPUT AMPS
PLASMA PLASMA
ENABLE ENABLE ON
START
REMOTE POWER SUPPLY CONTROL
SD (%)
25
75
100
50
TRAVEL TRAVEL SPEED SPEED
125+ IPM
0-125
IPM RUN
PURGE SET
A-00668
Figure 2-1 RC6010 Remote Control
A-00670
Remote
Control Accessory
CNC Control
Standoff
Control Assembly
Internal Ribbon
Cable
Remote Control
Cable
Power Base
Unit
CNC
Control Cable
Figure 2-2 TD-750 System Configuration
A-01268
Remote
Control Accessory
CNC Control
Standoff
Control Assembly
Internal Ribbon
Cable
Remote Control
Cable
Plasma
Power Supply
CNC
Control Cable
Figure 2-2 Merlin 3000 & 6000 System
Configurations
2.03 Specifications & Design
Features
A. System Compatiblility
The RC6010 Remote Control Accessory was designed to
be used with the following:
• TD-750 Plasma Cutting System
• Merlin 3000 and 6000 Plasma Cutting Systems